Refinishing a hardwood floor is an straightforward technique to add beauty and value to any home. It might also be a real ego boost for the do it yourselfer. Performing it yourself will save you money if you follow these effortless measures. Get a lot more facts about Golvslipning Stockholm

One of the most significant issue to think about when refinishing is usually a hardwood floor is cleanliness. You wish to ensure the floor is free from any debris. Debris can get caught in the sander and damage the floor. Tiny jagged stones would be the most damaging. In some cases it is not achievable to see the damage until following you apply your finish coats, after which it really is also late.



The baseboards are also yet another element you have to take into account. In case you are confident along with your abilities, you may gently take away them having a small flat-bar and a hammer. Take your time. The concept will be to take away and replace, not take away and then drive towards the hardware store due to the fact you broke the boards. You can leave the baseboards in spot if it is not practical to remove them. In case you pick to leave the baseboards, I recommend which you protect them with painters tape. The power sander will damage them when you are not cautious.



When the floor is clean, as well as the baseboards have already been removed or protected sufficiently, you can commence to sand. I recommend renting an orbital sander with a rectangular face. (Be cautious when transporting it to and out of your home and make sure you have a person help when lifting the sander.) Begin with 80 grit sand paper. Guide the sander smoothly more than the floor. Be sure you are sanding parallel using the joints within the floor. Try to not sand perpendicular for the joints, as this kind of sanding can damage the wood and result in the finish to look much less than best. The number of passes it requires to remove the old finish will differ from floor to floor. Be deliberate. Get rid of each of the old finish ahead of you move to a smaller girt sand paper.



Now that you are carried out sanding together with the 80 grit sand paper, you will would like to sweep or vacuum the floor. This removes any substantial wood particles or debris that may have been dislodged. As soon as cleaned, sand the floor in specifically the same fashion using 120 grit sand paper. You might notice the 120 grit sand paper sands pretty efficiently. That is since you happen to be no longer sanding through the old finish plus the sand paper is straight around the face with the wood. Endeavor to be smooth and fluid as you move the sander. Should you pause or cease, you can more than sand and produce low spots in the floor.



You are going to know when the sanding is comprehensive by the look and really feel in the floor. Visually you might not see any shinny or glossy locations. The floor may have a smooth and dry feel to it. Take you time for you to crawl around and closely inspect the floor. When you discover any regions that don't meet your standards, cautiously sand them again. As you sand more than the imperfections, be sure which you don't hold the sander in one spot to get a prolonged time period. Rather, make passes more than the location needing to be sanded; short ones 1st, followed by progressively longer ones. This method is known as feathering and can help protect against more than sanding your floor in any one region.



Following your final inspection from the floor is total, you are going to would like to clean again. Deliberately vacuum or sweep up all of the debris. Then, using a slightly damp cotton towel, wipe over the entire floor surface. After you are wiping, keep the towel in one orientation against the floor. Usually do not choose it up. The objective is usually to capture any compact debris left behind around the front face on the towel. You'll notice that the floor wicks a few of the water out of your towel. This is regular and will not influence your final finish as long as you allow it to dry.



In conclusion, refinishing a hardwood floor does not have to be tricky. Don't forget to clean the floor before you start off to sand. Clean the floor whenever you change the girt size of your sand paper you're using. When total, you will have a smooth floor able to accept its initial coat of finish.